你可能感興趣的試題

A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB. Later attempts to access NewSwitch using Telnet from SwitchA failed. Which statement is true？（）

A.Executing password recovery is required.
B.The virtual terminal lines are misconfigured.
C.Use Telnet to connect to RouterA and then to NewSwitch to correct the error.
D.Power cycle of NewSwitch will return it to a default configuration.

多項(xiàng)選擇題

Refer to the exhibit.This command is executed on 2960Switch：
2960Switch（config）# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1
Which two of these statements correctly identify results of executing the command？（）

A.Port security is implemented on the fa0/1 interface.
B.MAC address 0000.00aa.aaaa does not need to be learned by this switch.
C.Only MAC address 0000.00aa.aaaa can source frames on the fa0/1 segment.
D.Frames with a Layer 2 source address of 0000.00aa.aaaa will be forwarded out fa0/1.
E.MAC address 0000.00aa.aaaa will be listed in the MAC address table for interface fa0/1 only.

日韩欧美亚洲 _ 欧美亚洲一区 _ 日本亚洲欧美 _ 亚洲精品欧美 国产白袜脚足J棉袜在线观看_亚洲熟妇av一区二区三区_久久天天躁狠狠躁夜_精品众筹模特私拍在线

Which command enables IPv6 forwarding on a cisco router?（）

你可能感興趣的試題

A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB. Later attempts to access NewSwitch using Telnet from SwitchA failed. Which statement is true？（）

Refer to the exhibit.This command is executed on 2960Switch： 2960Switch（config）# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1 Which two of these statements correctly identify results of executing the command？（）

日韩欧美亚洲 _ 欧美亚洲一区 _ 日本亚洲欧美 _ 亚洲精品欧美国产白袜脚足J棉袜在线观看_亚洲熟妇av一区二区三区_久久天天躁狠狠躁夜_精品众筹模特私拍在线

A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB. Later attempts to access NewSwitch using Telnet from SwitchA failed. Which statement is true？（）

Refer to the exhibit.This command is executed on 2960Switch：
2960Switch（config）# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1
Which two of these statements correctly identify results of executing the command？（）