你可能感興趣的試題

The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？（）

A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q.

單項選擇題

Refer to the exhibit. When applying this policy map on the tunnel1 interface，you see packet loss for the TCP class starting at around 100000 b/s，instead of the configured 150000 b/s. What is the most likely？（）

A.The violate-action command should not be configured.
B.The current configuration of the load-interval command on the tunnel interface is preventing proper policing calculations.
C.The burst size is too low.
D.Policing on tunnel interfaces is not supported.
E.The CIR keyword is missing in the policer.

日韩欧美亚洲 _ 欧美亚洲一区 _ 日本亚洲欧美 _ 亚洲精品欧美 国产白袜脚足J棉袜在线观看_亚洲熟妇av一区二区三区_久久天天躁狠狠躁夜_精品众筹模特私拍在线

【簡答題】 在R2的show ip route ospf中，關(guān)于R1的loopback0的路由條目下一跳指向哪個路由器。

你可能感興趣的試題

The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？（）

Refer to the exhibit. When applying this policy map on the tunnel1 interface，you see packet loss for the TCP class starting at around 100000 b/s，instead of the configured 150000 b/s. What is the most likely？（）

日韩欧美亚洲 _ 欧美亚洲一区 _ 日本亚洲欧美 _ 亚洲精品欧美国产白袜脚足J棉袜在线观看_亚洲熟妇av一区二区三区_久久天天躁狠狠躁夜_精品众筹模特私拍在线

【簡答題】
在R2的show ip route ospf中，關(guān)于R1的loopback0的路由條目下一跳指向哪個路由器。

The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？（）

Refer to the exhibit. When applying this policy map on the tunnel1 interface，you see packet loss for the TCP class starting at around 100000 b/s，instead of the configured 150000 b/s. What is the most likely？（）